-
About AUTOSTAR
-
Products & Solutions
-
-
CONTACT US
M201
- Commodity name： M201
- Product Description
- 右侧描述
-
After reassembling the vehicle the system should be tested on the road in highway and surface street conditions. This system is capable of detecting a vehicle traveling in both directions, Passing and Overtaking.
4 A. Right Sensor TestingVehicle Passing
Drive the vehicle above 20km/h. When a vehicle approaches from behind on the right side of your vehicle, the right LED indicator should illuminate. While the Right LED is illuminated, activate the vehicle's Right turn signal. The system should begin to flash the LED and the buzzer beeps twice.
Vehicle Overtaking
Drive the vehicle above 20km/h. When your vehicle approaches and overtakes another vehicle on the right side, the Right LED indicator should illuminate. While the Right LED is illuminated, activate the vehicle's Right turn signal. The system should begin to flash the LED and the buzzer beeps twice.
4 B. Left Sensor Testing
Vehicle Passing
Drive the vehicle above 20km/h. When a vehicle approaches from behind on the left side of your vehicle, the Left LED indicator should illuminate. While the Left LED is illuminated, activate the vehicle's Left turn signal. The system should begin to flash the LED and the buzzer beeps twice.
Vehicle Overtaking
Drive the vehicle above 20km/h. When your vehicle approaches and overtakes another vehicle on the left side, the Left LED indicator should illuminate. While the Left LED is illuminated, activate the vehicle's Left turn signal. The system should begin to flash the LED and the buzzer beeps twice.
4 C.Rear Cross Traffic Testing
Park the vehicle in a heavily traveled parking lot. With your foot securely on the brake, shift the vehicle into reverse gear. When a vehicle enters the detection are a from the Left or Right, the system will flash the LED indicators and the buzzer beeps twice.
Kit Contents
System Layout
Configuration And Testing
4 A. Dip Switch Setting
The control Module has 4 dip switch settings that should be reviewed before testing.
No. Swtch status Definition Note 1 Off Reserve On Reserve 2 Off Reserve On Reserve 3 Off Working Speed 0m/h Default On Working speed 20km/h 4 Off 7m for same speed target Default On 5m for same speed target 
Harness Layout
LED &Buzzer installation
3 A.Left LED Installation
1.install the warning light on the A pillar, make sure the installation position could be easily seen by driver;2.Stick the warning light on the A pilar, please clean the surface before stick.
3.Route the LED harness to the main harness and make a secure connection.
3 B. Right LED Installation-N
1.Locate a suitable location for the Right LED indicator.
2.Stick the warning light on the A pillar, please clean the surface before stick.
3.Using the LED Extension harness, route the LED harness to the main harness and make a secure connection.
3 C.Buzzer Installation
1.Locate a suitable location for the Buzzer. This location should be accessible to the driver to make volume adjustments.2.Use the supplied 2 sided adhesive tape to secure the buzzer to the vehicle's trim panel.
3.Route the Buzzer harness to the main harness and make a secure connection.
Request
* Note: Please ensure the information is filled in correctly and maintain smooth communication. We will contact you as soon as possible!
Related
Xiamen Autostar Electronics Co., Ltd
No.190,Siming Park,Tong'an Industrial District, Xiamen,Fujian,361100,China